Installation Instructionsfor Tri-Five ChevroletsSteering Column to Steering BoxFOR PART NUMBER’S: 1120550010, 1120550020, 1120550051, 1070550030,
Note: Cut approximately 6” up from the box, a second cut will be necessary. Install the column after you cut the shaft so both shafts are touchi
10InstallatIon InstructIons for the classIc 1955-56-57 chevy – tIlt steerIng wIth column shIfter, usIng stock gear BoxA 3/4”-36 x 3/4” DD coupler will
Once you have the box mounted in position, a rag joint is used to connect it to your new column. This is a direct hook-up. This column uses
12Once you have the box mounted in position, a rag joint is used to connect it to your new column. This is a direct hook-up. The tilt column uses
steerIng wheel modIfIcatIons for 1955-56-57 chevys wIth stock steerIng wheel mounted on steerIng columnThe spline in your stock steering wheel is
14After market steering wheel with the short adaptor on the new column with shift and tiltAfter market steering wheel with the short adaptor on the ne
15Think you may have forgotten something? Here’s what you may have missed:Add Ons: (Add Ons should be installed on the column prior to shipment) Cru
Notes:16
ididit, inc.610 S. Maumee St., Tecumseh, MI 49286(517) 424-0577 • (517) 424-7293 faxwww.ididitinc.comNo part of this guide may be reprinted, reproduce
1Thank you for purchasing the Tri-Five Chevy column from ididit.This is a simple overview of how to mount your column. Any steering column must be sec
2The Classic Chevy Floor Mount is made up of two pieces:A.) T-shaped L BracketB.) ClampThe T shaped bracket mounts in the original bolt holes in the
3Turn Signal Lever:The turn signal lever is located closest to the top of the column. With the steering wheel and adaptor removed, look down at the to
4Wiring your ColumnThis ididit steering column uses a standard 3 7/8-inch male connect. However, some GM columns use a 4 ¼-inch male connector. Conne
Horn Button Wiring:A horn may require two wires to properly function with an ididit column. The center lug on the button should connect to a horn wire
Synchronizing your ColumnIn order to insure proper functioning, this steering column must be installed in sync with the rest of the steering system. T
Accessories Important to Installation: #2401400010 Classic Chevy Floor Mount This oor mount bolts through the oor in the original holes. It st
8How to make a DD ShaftThe shaft of the gearbox will now need to be cut into a DD shaft. This is a round shaft with ats centered on two sides. An eas
Commentaires sur ces manuels