for 1965 Ford FalconRetrot Steering Columnwww.ididitinc.com610 S. Maumee St., Tecumseh, MI 49286PH: (517) 424-0577 FAX: (517) 424-7293INSTALLATION IN
COLUMN SHIFT LINKAGE INSTALLATIONVerify that the transmission is in park and then shift the column into park. Next, compare the rotation of the lower
NOTES:www.ididitinc.comNeed Further Assistance?ididit, inc has been serving the rodding community for over 25 years and we take pride in our outstandi
ididit, inc.610 S. Maumee St., Tecumseh, MI 49286(517) 424-0577 • (517) 424-7293 faxwww.ididitinc.comNo part of this guide may be reprinted, reproduce
(A)(B)(D)(E)(C)The ididit 1965 Ford Falcon Steering Column comes complete with these components:(A) Column (Paintable Steel column pictured)(B) Floor
1OEM COLUMN REMOVAL:Verify that your steering wheel and driving wheels are straight. Disconnect positive battery cable.To remove the horn button on yo
The outer column, (Mast jacket) should now be loose. Gingerly wiggle and pull the outer cover of the column from the shaft. There will be years of du
Mark the shaft at the 8 vertical arrow points and draw a line down the length of the shaft, connecting the marks. This will create the shaded “D” sect
WIRING INSTALLATIONWe nd the following tasks are much easier to do on a workbench before installing the column into your car.New male and female conn
If you have purchased a shift indicator for your column shift column this is the time to install it. Follow the instructions that were provided, but p
6secure with tape so that it is out of the way.You will be re-using the original dash mount so check to make sure the rubber on the U piece (Figure 12
KNOB & LEVER INSTALLATIONOpen packaging and install the knobs onto the levers. The shorter lever is the tilt lever, and is threaded into the hole
Commentaires sur ces manuels