ididit inc. 610 S. Maumee St. 49286 Tecumseh, MI PH: 517-424-0577 FAX: 517-424-7293
www.ididitinc.com
Collapsible Floor Mount
with Plate Installation Instructions
For Part Number’s 2401020010, 2402020010, 2401120010, 2401220010
Instruction #: 8000010251 REV 04/14
This oor mount is designed to mount a steering column to the oor
or rewall and can be installed on either side of the body. This mount
includes extra material used to repair any holes in the rewall left
behind by the existing steering column.
1. Choose the location of the mount. This should be a at surface.
Note: The mount can be rotated in any direction. Cut out the
provided template and use it to help determine where the mount
will be located. Use a punch and mark the three locations
indicated with the X on the template. (Instruction # 8000010498,
8000010499, 8000010500 or 8000010501)
2. Trim this piece as you see t, keep in mind that the small plate
will be positioned against the large plate with the smooth side
down. Also note that if there are pedal interference issues, make
sure the bolt and nut do not end up in the way. (Figure 1)
Note: If welding your new plate make sure to remove the O-Ring.
3. Once the plate is tted inside your vehicle you can then start to
assemble the oor mount to the column. Slide the anged plate
onto the bottom of the steering column tube with the ange facing
the top of the column. Next slide the O-Ring onto the column.
(Figure 2)
4. Install the column through the oor plate while retaining the order
of the oor mount pieces. (Figure 2)
5. Use the provided hardware to secure the oor mount to the oor.
Slide 1 at washer and 1 lock washer on each of the bolts and
thread the bolts through the holes on the oor mount. These bolts
are to be torqued at 11 ft. lbs. (Figure 3)
6. Your installation is now complete!
*PLEASE NOTE: The enclosed oor mount has a “hot dip” black oxide
nish. It would be important to put a permanent nish on it before you
install.
Commentaires sur ces manuels